hi lads I really appreciate any input and your time with this, I've always been the hammer and fettle type... but think its time to change lol...
it will be starting at anywere between 8-48 bar but i can regulate its start pressure to a fixed pressure where ever is best. its 10cc @ any pressure...
it looks like we are on the right track, Iam still stuck on the maths of sizing the turbines :( . am not going to use steam to produce the pressure, its compressed air heated up to min 10c @ 8bar max 65c @ 48bar with a compressor displacement/stroke of 10cc... I can build the unit but really...
thanks for the replys I was going to use 3 generators and 3 turbines but am limited on space with in the unit, I think you may be right about balancing them down a shaft
hi all am looking to do a project using triple expansion of gas like the old steam engines had. I've got 3 points of gas/compressed air at different pressures to run 3 turbines. am thinking of using a central shaft and sizing the turbines to produce the same rpm and torque down the drive...
thank you for your replies it looks like I will be using ac generator and will have to do some gearing to get the torque required ... hi phinds 1) yes I do know differences between voltage, the voltages i listed are optional for a inverter input to produce 240v 2) yes I do know the difference...
hi all am doing a project to generate 240v 2.2kwh at 10 amps out put volts can be 28/48/24/12. i can't figure out what type of generator to use ac/dc, 3phase, permanent magnets, induction, or axion flux. I need one with low friction low torque under load an low rpm as the source to spin it up...
say we base the motor on this type were the coil is out side and the rotor is in the center
see attatched pic..
on the second pic (best i could find to show the field) picture the magnet as the spining motor C & D.
on the field A, E & B what's happening to the field in relation to north...
hello sorry for the bad description I've always loved physics since i was in school so I've decided to start a project so please forgive my lack of technical wording and ignorance i promise am a quick learner lol
on a motor we use electricity / current passed though a coil to create a...