Recent content by Cubeclub

It works. I bought the 470K ohm resistors today. It's so amazing. Thank you!

Thanks for all the help. I have to go to sleep now. It's 2:12 am

You live in Australia? I see it in your profile. cool

North Bellmore, NY

470 K would be yellow, violet, yellow wouldn't it.

just shoot me. OMG. I can't believe I missed that. I was looking for something harder. I had the circuit on top of a cd case. Is that what you meant by where are you?

Same as this

No It isn't

*Fix* Pin 1: 0V Pin 2: .1V Pin 3: 5V Pin 4: 6.4V Pin 5: 4.3V Pin 6: .1V Pin 7: .1V Pin 8: 6.4V

I am using a 6 volt battery and I got these voltage readings. Pin 1: 0V Pin 2: 1.9V Pin 3: 5V Pin 4: 6.4V Pin 5: 4.3V Pin 6: .1V Pin 7: .1V Pin 8: 6.4V

The LED goes on and when I connect the two wires where the switch would be the LED dims slightly. I put in a .47 Capacitor and I still had the same outcome.

Thanks. I'll try putting in the .47 uF Cap. I'll also reduce the size of the pics. Should I reduce them here or just in the future?

I'm not sure if this is the right forum to put this in and I never took photos of something to put on the internet but I can't get this circuit to work and I need help. The LED is normally on. When I press the switch the LED should blink, slow down until its original condition. Maybe this should...