Recent content by deepaknatraj

Thank you for the reply. That makes sense. And yes of course i'll put a barrier between the test equipment and me.

This experiment is to find the holding power of a seal. I'm planning to seal both sides of a component (a tube with i.d of 1.5" and 2" long) with the seal and pump water into it. To flush out the air inside, I'm tilting the component as much as i can while pumping water into it. the idea is flow...

Hello, I have a question regarding the effect of compressed air. I'm working on hydrostatic pressure testing a component. The component will be filled with water and compressed to 1000 psi. I'm concerned about the small amount of air that'll be present inside and worried about the effect in...

How do I find the force acting on the helix of a thread. Say if I'm using a torque wrench to tighten a nut and compress a gasket between nut and a mating piece and give 100 ft.lbs of torque how much of it will be available on the helix of the thread (say a helix angle of 0.67 degrees)...