Recent content by Duraga

First off thanks for all your ideas they where extremely helpful.Turns out the rebuilt aftercooler did not have a baffle plate that is required on the very inside of the inlet it is designed to do two things 1 spread the water across the whole aftercooler and 2 slow water flow down enough to...

Thanks for your input brewnog i definitely have thought of some sort of line blockage at this point as well but upon inspection at various points throughout the system there is at this time no actual evidence found yet to support that. And upon start up right after completion of the new...

Thanks for the interest Danger,first off this system is opened loop that consists of a aux pump 24psi then an aftercooler that transfers heat from the turbocharged air for the intake to water that runs through the aftercooler this water then runs outside to a "marely tower" that has cools off...

Thank you for the welcome and yes you are right it is for a large 2000 horsepower turbocharged 8 cylinder worthington sehg natural gas industrial engine that is used as a prime mover for a large natural gas compressor.

In my humble opinion a report on combustion if i wrote it would consist of the history and fundamentals of internal combustion it is a fascinating topic and today is used for such a wide variety of things you could report on any application you are most interested in such as...

I have a intake manifold temperature that is way to high (105 by mid day normally 90) that is killing me.I have replaced the aftercooler and rebuilt the aux water pump that supplys the cooling water to the aftercooler as well as cleaned out the secondary cooling marely tower,all to no avail is...