Recent content by florian245

Sure for the detail 11 but the loss starts way before 0.4mm The thickness is about 4 mm. The yield point is upper than before Yes clearly but the 4° taper starts 6 mm before the end of the assembly and the loss of effort is 1.5mm only before the end of the assembly.

As you can see the profile of my bushing is perfectly cylindrical. until 0.001mm almost So it would be another issue :rolleyes: I will try to increase the size of my part hole diameter

Hello thank you for your answer, clearly between 46.5 and 47.1mm it's this but the main point remains the loss of effort that exists in some cases and not others. I give you some more details, my shaft is the 15 mm diameter hole in this following part (because the one of 14.5mm is for a smaller...

Hello everyone I intent to resolve this issue for some days already but i can't figure out what's wrong At this moment i use a kind of bushing which give me a curve like this : As we can see I have between 46 and 47mm my effort reaching a constant value of effort for the 3mm of fitting...