Recent content by gitagituy

What do you mean? I do not completely understand I'm not sure if my professor specifically told me to use both together.

sorry, I didn't pay attention. is this the code? 6 sz 146.1 7.0 [Spam phrase redacted by the Mentors] 6 sz 106.1 3.0 I have changed it to mode p SDEF POS=0 0 0 ERG=d1 PAR=p SI1 L 0.001 0.004 0.006 0.008 0.01 0.02 0.03 0.04 0.05 0.06 0.07 0.08 0.085 SP1 -2 0 0.085 F6:p 62 63 64 65 66...

I have to finish this before the end of April. I am using version 6.2. I plan to analyze bremsstrahlung x-rays. I tried to send the code that I have created. Is there still something wrong and lacking? because I tried it and it still gave a fatal error. please help. thank you very much

No, I'm not trying to cheat. I apologize for looking like I'm trying to cheat. I just want to try to understand this mcnp. That's why I made this question in this forum I'm just still confused in writing the energy and tally used because my lecturer said that it can't be written directly erg=...

the units is Sv so how do i write the energy? is the tally i use f8 or what? do you have any recommendations on writing the material for me?

First of all, I apologize, I don't really understand what you mean. I also don't understand how to convert the flux into isotropic source activity. Can I just use sdef erg=0.085 pos= 0 0 0? or how? my lecturer said, I have to look at other people's theses that also convert kV to MeV. when he...

means in the cell, am I still wrong? yes. i understand why #66 is needed if using single energy what will it be like? what is the right thing that i should use? because my lecturer said this is easy to do and still very basic to write a data card actually the purpose of this program is to...

my lecturer said that there is no need to make an x-ray tube but the source is a point that spreads. I am confused about defining the data card especially in the sdef and tally sections. are the sdef and tally like this code? please check it

here is my code please check it thank you

For computation physics in my college. I have studied and understood the cell card and surface card sections. However, in the data card section, I do not understand when converting from volts to electron volts. I tried to read and study through the manual book and my senior's thesis, but in the...

Dear all, I want to simulate an X-ray tube and check the dose rate in the room. My problem is in the data card. I don't understand how to write sdef, tally, and others. I simulate 85kV with 25 mAs and the source position is at 0 0 0. Regards, anggi