Recent content by Growling_Mango

To be completely honest I'm not too sure which connection it was. I ran through a bunch of them again just to make sure everything was set. I jumped into this thing with a very limited amount of knowledge so it's been fun working through it and figuring everything out, even if it's little by...

I actually just found out what the problem was! It turns out my solder job wasn't has good as I thought and after closely inspecting it found a few dry joints.

They do not have DC voltages for the nodes unfortunately. I may be misunderstanding the last question but the transformer I'm using is this http://www.newark.com/hammond/166m24/isolation-transformer-24v-72va/dp/51R4207, if that answers your question.

Here are the photos.

Hi! I'm trying to build a variable voltage DC regulated power supply that is 0-30v and 2mA-3A. The problem I'm having is that as soon as I plug it into get a reading on my multimeter it reads 34v, even if I try turning the pot it does not change. I've rewired the pots and made sure the...