Recent content by ha700

I have found TC4426-TC4428 drivers if these would be any good to use? http://html.alldatasheet.com/html-pdf/26044/TELCOM/TC4428CPA/935/5/TC4428CPA.html I am doing this circuit as part of a university course so sadly I need to build the h-bridge myself, not buy one as good as the ones you have...

If I used the IRS2453 with the mosfet transistors stated previous what type of load could I drive? Set up like the circuit within the datasheet. http://www.infineon.com/dgdl/Infineon-IRS2453D-DS-v02_00-EN.pdf?fileId=5546d462533600a40153567ac42f2814

For the h-bridge I am using STP140N8F7 in the high side and either IRFZ40PbF or 2SK3845(Q) on the low side. The loads are 500W 24A DC motors and I think they will be supplied with 12V batteries.

http://www.infineon.com/dgdl/Infineon-IRS2453D-DS-v02_00-EN.pdf?fileId=5546d462533600a40153567ac42f2814 I currently have a H-Bridge circuit and would like to use the IRS2453DPbF to power it. I would like to do this using an Arduino but am unsure on how the Arduino connects up to the driver. It...

I have chosen the N-channel MOSFETs as they are cheaper and I only have a £50 budget for my entire project as I need to build 2 H-Bridge circuits. I went to my tutor for advice on transistors that I found and they suggested a range of 60V / 70A. At the moment I have purchased both N and P type...

As part of a group project I have been given the task of building a H-Bridge circuit to replace a previously built one in a fighting robot. I have no access to what this H-Bridge looked like or what transistors where used etc. I understand only the basics of a H-Bridge about how it works and...