Recent content by Hamed Farnaghizad

@gerbi It is actually simulation of an analytically designed axial flux FSPMG, which is based on a journal paper. I will do your suggestions. I hope getting good results.

@gerbi Hi again Sorry for delay in response I checked everything and all the things look ok. I think the problem is of the circuit, I used circuit editor of maxwell. I wanted to have a Delta-Delta connection but It needs GROUND so I don't know what to do to have a DD connection.

Well, I changed output circuit as the picture attached below, but no good result. Actually by changing the resistance of the load output voltage of the generator varies!

Dear @gerbi I connected three phase windings in delta connection and connected to a three phase Y connection 100 ohms load. As I calculated torque should be around 47 Nm. One surprising thing is that , No load and Loaded Torques are the same!

Hi @jrmichler Thanks for your reply, actually I thought it may be a common problem in ansys maxwell. I am simulating a 1KW axial flux switching generator. I need to have its output voltages and electromagnetic torque. Output voltages are acceptable but torque (moving toque in rectangular plot)...

Hi guys! I do have a problem in ansys maxwell simulation of a generator. The moving torque (which represents electromagnetic torque) fluctuates around zero which is not correct. Induced Voltages are ok. How can I fix this problem?

@RanchodDasChanchad I do have the same problem! what you did to solve the problem?