Recent content by happytolearn

I am using Moving_heat_R150_v3 ACT extension in ANSYS Workbench.But while solving the problem it shows following error- SOLVE is not a recognized PREP7 command, abbreviation, or macro.This command will be ignored. It seems to be like there is a problem in the extension.Is it possible to edit it?

yes I have used nonlinear (temperature dependent)material property. I am now trying to see the effect by remeshing according to your advice. One thing can we cool the assemble by applying cooling cycle?I have linked the transient analysis to a new transient analysis where i have omitted the...

No i have just given heat flow,convection and radiation.should i add any other boundary condition?What is the thing i am missing. Please help.

Maximum temperature is coming 6042 .8 and minimum -132.52! Though i have selected initial temperature as 22 degree centigrade.

I have tried to analyse the result by activating and deactivating one after another.But still it is coming very high temperature.One thing to mention i have applied the boundary conditions to the whole assembly(welding zone and the two plates).What can be the other possibilities for the...

It is coming in a region when I run the animation. I have selected the initial temperature as 22 degree centigrade

I want to do a transient thermal analysis in butt welded joint.The heat flow I have given 3200 watt(Q = efficiency x current x voltage = 0.8 x 160 amp x 25 volt)to the welding zone, given 20 load step(as welding is completed in 20 sec),convection co-efficient = 11.14, emissivity = .4 and applied...

thanx bigfooted i will check it

Is there any other way to model the moving heat source in ANSYS Workbench?

Please help.I want to do transient analysis on welded joint.So for moving heat source I have to select multiple patches along the weld joint.From tutorial I came to know that it can be done by imprint faces while extruding lines,but when I tried it by extrusion in operation it does not show the...