Recent content by HavensXL

Here are attached links to videos of the mechanism in motion.

This clears so much up, translation along a curved plane will exert an equal force as long as the plane is ridged. If one well had a larger mass in the corner of the plate would that effect any of the wells around it? Or is it isolated because again the plane is ridged?

I tried to attach a video but it was not supported. I'll try something else.

Ill see about a diagram, the tho cams that are placed at the top and bottom drive the center of the top and bottom plates(the one depicted with the two colored wells is one plate, another one is placed below.) the center gear spins causing the other two to rotate with a pin that is of center...

Depicted is a plate of 48 wells on a ridged plane that is rotated or stirred using a hub with an off center pin to mix a fluid in each well. My question is thus: Do all wells experience the same amount of force or does the red well experience more/less than blue? I would assume that the forces...