Recent content by Hoya

Basically I'm trying to design a solar inverter which contains printed circuit board with electronic components and electromagnetic interference filter inside and LED touch screen display that is going to go on the top lid of the enclosure. If I use a die-cast aluminium enclosure then I do avoid...

Putting it into a well-vented stand off enclosure might be better as making the heat sink bigger increases the cost and weight of the product. On the other hand, the top lid of the aluminium enclosure might still need to be opened if the product is not functionally properly and the installer...

Hi there! Is there any ip65 rated enclosure material with electronic components inside but with no holes/cutouts that can act as a heat sink without overheating while the product is operating? Enclosure will need to be wall-mounted outdoors, it could be made out of die-cast aluminium which...