Recent content by John Kenneth
-
J
Unsure Regarding Temperature Model for an Open System
I tried to edit the links to the photos now. Does it work now?- John Kenneth
- Post #10
- Forum: Materials and Chemical Engineering
-
J
Unsure Regarding Temperature Model for an Open System
Chestermiller: I have not tested the whole system for steady state and transient for an ideal gas. Along the way, while building the model using matlab, I have compared the results to that of ideal gas for special cases to verify that the results are not too far off. The system is acting like a...- John Kenneth
- Post #8
- Forum: Materials and Chemical Engineering
-
J
Unsure Regarding Temperature Model for an Open System
Regarding the RK equation, I am supposed to model the gas via some non-ideal gas equation to investigate the differences between ideal and non-ideal gas. So therefore I have to assume non-ideal behavior. The reason for converting to enthalpy on the left-hand side was simply because the...- John Kenneth
- Post #5
- Forum: Materials and Chemical Engineering
-
J
Unsure Regarding Temperature Model for an Open System
Hi, I also think that my final expression seems a bit complicated, and I might have been a bit confused about all the different approaches available. When it comes to added complexity, I can tell you that the gas flow will vary in direction a lot. Therefore, the model should simulate a...- John Kenneth
- Post #3
- Forum: Materials and Chemical Engineering
-
J
Unsure Regarding Temperature Model for an Open System
Hi guys, I am currently working on my master thesis. I am supposed to make a dynamic model for a gas system and have some trouble setting up the energy balance. I am a noob when it comes to uploading pictures, so I don't have a figure for this, but let's consider a general control volume (CV)...- John Kenneth
- Thread
- Energy balance Enthalpy Model Open system System Temperature Thermodynamics
- Replies: 12
- Forum: Materials and Chemical Engineering