There isn't an led driver circuit. This system consists of a 25w halogen bulb, 2 194 bulbs, 2 921 bulbs. The led headlamp I am using will not be part of this circuit.
I simply want to eliminate the 25w bulb, and either leave it disconnected, or install a resistor in its place , or replace the...
OK, here are some shots of the manual. This first page talks about the resistor and bulbs burning out
And here are other pages on the system
I believe that is everything. That first note a about the resistor and lighting is where I'm getting my info from.
I will try it out. Worst case is the instrument bulbs burn out. I was going to put it on it's own circuit with a relay so it is switching +12 directly from the battery to the light with larger, newer wire instead of running the power through the original wiring where it also has to go through...
Are you saying that if disconnect the headlamp and run it on it's own circuit (as explained in the op) that I could just leave the 5w in place without having to goto a higher watt part or add one in place of the headlamp?
This system just throws me off because it's not like a normal automotive...
Correct. That is the auto choke. However, the auto choke no longer exists since the engine has a different carb on it now with a manual choke.
The problem with your suggestion is that the whole point of doing what I am doing (aside from having an led headlamp) is to have the choice of the...
Hello there.
I was looking for a place on the web where someone with an electrical understanding might be able to help me.
I have a gas powered scooter which I wanted to make a change to the lighting circuit. My question is regarding the resistor in the circuit. With this circuit, while the...