Recent content by jzcrouse

12.5 gpm is 48.125 in^3/s. I can't change flow rate. The flow should stop before the container is full because the container will not be getting clean when it is full of water. at steady state I'm getting only about half an inch to maintain at 12.5 gpm. Using your program i am finding i need...

updated the initial post

working on clarifying

<< Mentor Note -- thread moved from the schoolwork forums to ME for better views >> 1. Homework Statement Not really homework as this is for work. We are washing a cylindrical container (15.5 cm) with only one (1.8" dia) hole at the bottom the rest is sealed. Our machine sticks a .5" pipe with...

I have a wire used for cutting cheese that gets pushed horizontally into the wire repeatably. Naturally the wires break as the wear. Currently, we just tighten the wire until it seems good but I am unsure how much the pretension in the wire influences the rate the wire breaks. I was looking to...