That is a very good idea Nik however i don't want to impinge the flow of water through the strainer. There is a seem on the one i have currently however I am not quite sure if it stuck together by adhesive but blowing air through the seam it doesn't seem to be.
http://www.globalvalves.com.au/valves/STRAINER%20VALVES/STR-74A-Rev01.pdf
Ok the strainer is much like the one above and you can get the mesh in steel, alumin, ss etc. Its used to filter water being injected at pressure into some jets for underground coal dust suppression. We were looking to...
Hi I need a way of joining a very thin strip of stainless steel mesh to form a cylinder.
It forms the 300 micron mesh cylinder that sits inside a inline "Y" type strainer.
The one i have currently doesn't seem to be joined by adhesive but by a heat crimp or sum sort of non...