Recent content by nomi114

Got it dear Sir, I am still woring on it. and soon i will share with you my output results. Once again thank you so much for your kind support.

sure sir, let me try this.

By using these commands, I have the following graphs. I am not sure how it can be defined or if it's correct or not. Need suggestions, please.

Dear Sir, Bundle of thanks for your guidance. I have followed your instruction but am still a little bit confused about drawing these graphs. I used the following commands for the simulation at first: .step param Pin -20 20 1; Sweep input power from -20 to +20 dBm .meas Vout_max MAX V(Load)...

Thank you so much, dear Sir, for your kind and prompt response. Here, I would like to inquire about one question: there is a small step phase variation in each (almost) output signal. I am a little bit confused. Why is there this variation? Is this a circuitry issue or what.........? Thanks in...

Thank you so much for your kind reply. If you don't mind, could you please help me understand how to implement these commands in my schematic? I have tried but was unsuccessful. I am currently stuck and would highly appreciate your guidance. Thank you in advance for your cooperation.

Greetings to all, I am writing with a question regarding graph generation in LTSpice. I am using LTSpice XVII and am trying to plot AM-AM and AM-PM characterization for a power amplifier, but I haven't been successful yet, likely due to my lack of practice with this specific analysis. I have...

Dear all, hope you are doing great. I have been working diligently on the hardware issue, but unfortunately, I have been unable to resolve it. After connecting the relay to the single-Chip IC (STM32 103RTC6), I noticed that there is a disturbance in the voltages. I have attached my schematic...

Thank you So much sir for your kindness and help. As the other mentor gave me some suggestions, I am working on it. If I didn't resolve my problem, then I will upload my query again here. Thank you, again dear Sir.

Dear all, hope you are doing great. I am designing a circuit using EasyEDA simulation tool. But I am facing a problem after connecting the relay to the single-Chip IC (STM32 103RTC6). The low voltage is showing around 2V, whereas it was originally supposed to be 0 volts. I am still unable to...

Thank you very much, Sir, for your generous assistance and valuable recommendations. I will proceed to download the file and diligently work on it. Should I encounter any ambiguities or issues, I will not hesitate to seek your guidance once again. Your kindness is greatly appreciated.

Yes sir, you are right, I have design it for the 50 ohms. its frequency response is good. so i think there is no issue with the BPF.

Dear Sir, Thanks for your kind reply. There is no specific requirement as you mentioned. I Just would like to enhance the voltage level at the output and output power as high as good. In some books i found they achieve the output power about 20-30W. I wish i can get too such wonderful power at...

Thanks for your prompt reply. The question you asked is quite interesting for me as well. Because I tried to calculate the output impedance of MOSFET, but unable to find exactly impedance. According to the datasheet the output impedance f IRF510 is 0.4 ohm. The output impedance seen by the FET...

Thanks for your kind reply. This PA can be used for RFID Applications (Frequency range 7.7MHz ~ 8.7MHz). Yes, i am using LTSpice simulator, I tried to upload .asc file but fail. Sure, i will attached as text file for your perusal, pls. Thanks again Sir for your kind help.