Recent content by Nygie

Thanks for your reply NeonJohn, I had found the disection of the original mini-ductor. Great strip down! I have a lot of reading to do! Thanks for the links. Yes, you were right I am in the UK (the country were we get ripped of for everything!, they're even talking about taxing our hot pasties!)

Sorry yes KHz my mistake! DOH

Thanks for your answer Jim. I read 300GHz is pretty much the best frequency for steel. One project I looked at used a car ignition coil but they do not give any circuit specifics. http://blog.makezine.com/2008/03/25/diy-induction-heating/

Hi, new to the forum. Great place but much of the info far past my interlectual understanding. :frown: I have been looking at the idea of an induction heater for use in my job. I'm a mechanic by trade, nicknamed proffessor screwtop by my workmates :) Snap recently introcuced the...