Voltage drop is negligible, RC constant is not affected as it has very negligible resistance. Question remains is, for a rough estimate, how much cross-sectional area does it require to withstand 800A-1000A for duration of max. 3 or 4 seconds, voltages being 200/250 at 50 Hz. Thanks for your...
Isn't it like simple KCL problem? If you are connect a capacitor across the source that is in parallel, then the current will be diverted into two diffrent paths. ? :smile:
Also, My circuit maker simulation says that power factor won't be unity after adding 28.35 uF capacitor across the load...
Hello Guys!
I was designing copper bus-bars which can withstand 1 kA current. Actually I am going to discharge a several DC capacitors into those bars. So, I was confused in the dimensioning the cross section. Is 25mm * 3mm cross section enough? I have made my calculation using 1.6 A/mm2...