Recent content by Petrol Guy

Ya we measuring the dielectric constant, I just trying to figure out how it is done in order to troubleshoot or apply an offset if required. The horizontal lines is a 1/4 inch thick piece of metal which divides the pipe into two. On one side the permittivity is calculated and on the other side...

That sounds to be what I'm after (not sure if the same principle as plates but using an attenna like receiver [circular bars]). As for a general geometery it is imaged below. I do have the permittivity values at set amplitudes and phases, the frequence of the wave and lots of data (amplitudes...

First of all I will being with I'm not an electric engineer so I might be out of my wits, but I will give it a try. So I have an instrument which reads relative permittivity using a transmitter and two receiver placed at different distances. The instrument is calibrated to read either in a...