Hey all,
I never studied hydraulic circuits but I needed to design/make a hydraulic system for some research equipment. The system (in the attached schematic) has been hooked up and used for 6 months or so. However, I think we went the hard way on with getting the air out (we had no idea...
inconel is Inconel 600 (72-14-8 Ni-Cr-Fe or something close to that) and the ceramic is titanium oxide, lead oxide, and zirconium oxide, if that helps. currently we using an argon environment for the brazing.
we have been putting a small piece of the In-Sn solder between the inconel and...
i am doing some research for my university involving soldering an Inconel to a ceramic. i am new to soldering in general, and I am new to this lab. the inconel is nickle-chromium (dont know the composition) and i think the ceramic is Ti-oxide/Zn-oxide/Zirconium-oxide or something. basically...