Recent content by Roberto palacio

Need to change post to utilizing flywheel as a blower/supercharger

Had this idea today in my garage when I was setting up timing marks on the crankshafts and flexplate,the front engines flexplate would not be spinning the transmission.The flexplate is 14 inch diameter could you weld a series of fan blades to the flywheel face, get a modified bellhousing create...

got a twin ls1 standing mile car project I've been toying with for a while.My question is the engines have beeen fit in the engine bay with the rear motor having minimal setback to allow room for the front engine,the total weight for both engines is 760 lbs,half of that weight is ahead of the...

That's how I was looking at it launch off idle with both motors running somewhere in the 2-3k rpm range the electric motor would cut out and decouple from the engine.If the batteries were charged I could possibly drive around on the electric motor only just letting the gas engine windmill along...

As for the current gas engines the engines are bolted together with no gearbox in between the engines are GM ls v8s max rpm 6500.A big DC brushed motors I seen have a same max rpm of 4000 rpm.

Would it be possible to couple and electric motor to gas engine in series so both would increase the overall power.I currently building a twin engine car with two gas engines coupled together crank to crank like the old school twin dragsters.I would like to connect a large D.C. Motor in front of...