Recent content by santeria133

I attached I reattached the photos in my last post to clearly show my design and swingarm. I've had a good look around for a mechanical drawing of my swing arm to no luck unfortunately. One thing I have found is another similar swing arm analysis in which the user, similar to me, has...

Hi again, I have attached below 1picture of my gs500 with the stock swingarm in place. The other picture shows a rough draft of my concept . As you can see, the two arms are made into C sectional beams where a titanium plate with an axle insert will clamp against the end of the arm to hold the...

Hi all, For my final project at university, I am required to design a new swing arm for a Gs500 Motorcycle. I have come up with a C sectional concept when regarding the side beams and will insert X shaped reinforcement throughout the areas of less strength. My main problem is inputting the...