Recent content by sinkjk

No it would be a 1 1/2" wide bar by 3/8" thick

I appreciate you trying to answer. I will be able to watch the attachment points to see that they are not loosening, so I guess I am not as worried about that. I am attaching them using 5/16" stainless steel screws with lock nuts, just like the company does. I can tolerate the metal bending...

I'm sure you are smarter than me, but you are trying to make it a lot harder than it is. Please look at the picture again. Look at the bottom. You can see the bottom bar going from left to right. On each side of the reflector, you can see a screw. That is attaching the arm past the center...

The extension arms are made for the weight so they are not a problem. The lift is also made for the scooter weight so it is not a problem. If you look at the picture you can see the crossbars that come on the unit, that is if you buy it made for the scooter. The only question is: does it...

I got a lift which goes into the trailer hitch in the back of my car for my wife's scooter. Only problem it was made for a wheelchair. I found the extension arms so I only need to come up with the 4 cross bars. When I lift the unit, the tires of the scooter and the weight will sit on two...