Recent content by Vaibhav Mestri

If I make cylinder to pull the arm upward than pushing it from down like it is now will make difference?

I am attaching here pdf file for your reference. It shows how I made it & where it failed.

I have done BE Mechanical from University of Mumbai India. I have worked as design engineer in couple of companies, Now I run my own workshop to manufacture & repair hydraulic cylinders. I have experience in designing hydraulic actuators. This is kind of new project I am working on. This...

Actully I am concerned about actuator position. I tried couple of positions for actuator but didn't work. All the time in trial run arms bent. Also I am not sure whether my calculations for arms & rest of the structure were correct. Can anybody help out with complete design from beginning.

Hello guys I want to fabricate hydraulically operated scissors lift. I preformed calculations & fabricated same but unfortunately it didn't work. Can anybody help me out to design it again. Required specifications are Maximum load: 1000Kg Open height: 1500mm Closed height: less than 375 mm...