Recent content by yguvvala

Hi, The following is the description of CLHEP which was advised to install with GEANT4 in the installation Guide at http://geant4.slac.stanford.edu/tutorial/installation/Geant4.8.3/Linux/Geant4_8_3_Linux_Installation.htm#_Getting_and_Installing CLHEP: CLHEP is a set of base...

Hi , Please find the attached outputs ... Thanks, Yugi

Hi, Please find attached binmake.gmk i zipped it to upload it. Thanks, Yugi

Hi, I could not find binmake.gmk but i found another .gmk file which is hadlist.gmk which i attached, he make file is full file not an extract. i also attached the log file, and some more files which might be use flu to understand it that can be found in the folder attached. there...

Hi, Please let me know why are the more information you need. I am trying to use Geant4 for particle path tracking, so i have started my work and am in initial stages. I installed Geant4 on ranger system of TACC, i followed same steps as mentioned in the link and nothing other than that. At...

Hi, I have done a new installation so i am trying to compile the example code as suggested in http://geant4.slac.stanford.edu/tutorial/installation/Geant4.8.3/Linux/Geant4_8_3_Linux_Installation.htm to check if the Geant4 is installed properly. My application is to track particle path. to...

Hi, yes this is a example application and it needs graphics to run how should i install graphics lib files and change the path so that this would work i want to check if the Installation was really successful before i proceed in my work, below is the make file of the example application...

I did that but no help :(

Hi, I have installed Geant4.8.3 and i was prompted that i have installed it successfully i installed according to the instructions here (http://geant4.slac.stanford.edu/tutorial/installation/Geant4.8.3/Linux/Geant4_8_3_Linux_Installation.htm ) i am trying to check my installation by...