Recent content by yvesj

thank .that one did open . here is a few knifes pictures that i have left here . all my blades knifes are mirror polishe .and i do all my knifes cases . a knife cust me about 55.00 material and i sell them 125.00 . so there is not much money here .it take 5 hrs from the start to finish...

has for a washing machine motor . no .i need a motor with a fan at back because i am grainding steel .stainless steel .etc.etc .no wood what so ever . only steel

thank .but i can't not open any of the 2 link you gave me .

this is what i like to do .but 6 inch and reversable

is this the way to fix the wires on the switch

thank you . yes i am looking at a good wiring diagram .i did find a fews of them on google . like i said i do have a few brand new switch .on-off-on . if i can't not do it i guess i will have get the motor to a electric motor shop or get a good electrician . right now i was working on my new...

the motor i had the switch was a on-off-on . now i do have some here . no i did not buy the motor yet . 150.00 from amazon.com .192.00 at my door .not bad at all . this is the best set up to but back a hedge on your knife if you know how to use wheel [6 ]800 grits]but after doing at least...

thank you . i was a knifes maker from 1993 to 2007 all i know is i did buy the same motor but a 1/2 . the place that i got the motor did set up all wiring for me to connect it to my switch . but because of my age and i had to move from my place i had to sell all my knifes making tools ...

Electric all purpose motor has 1/3 HP, 1725 RPM and rigid base. Also has capacitor start, 5/8in. shaft size and NEMA frame #56 for long lasting durability. 115/208-230 Volts. U.S.A.

115/208-230 volts 6.4/3.2 amps 60hz TEFC - Totally Enclosed Fan cooled - Electrically Reversible Manual Overload Protection - Service Factor 1.15 NEMA 56 Frame - Flat Rigid base mount - 5/8" Diameter shaft x 1 7/8" Class F Insulated - Ball Bearings w/low temp grease

hi .i am new here i like to know if this motor can't reversed using a switch from turning right to left . i am a knifes maker [was] and my motor have to turn clock wise and counter clock . thank you . yvesj