pivoting rod help

[Juntao]

Picture is attached.

A rod with mass M = 1.4 kg and length L = 1.2 m is mounted on a central pivot . A metal ball of mass m = .7 kg is attached to one end of the rod. You may treat the metal ball as a point mass. The system is oriented in the vertical plane and gravity is acting. The rod initially makes an angle theta = 27 degrees with respect to the horizontal. The rod is released from rest. What is the angular acceleration of the rod immediately after it is released?
-----------------------------------
Ok, first I converted 27 degrees to .471 radians.

Now, I know that Net torque =I*alpha

or net torque = [I(rod)+I(point mass)]*alpha

so I got it set up like this

r-r*m2*g*sin .471=[I(rod)+I(point mass)]*alpha

where r is 1.2m/2=.6m
m2=mass of ball=.7kg
m1=1.4kg
I(rod)=1/12*mL^2=(1/12)*(1.4kg)*(1.2m)^2
I(ball)=mr^2=.7kg*(.6m)^2


So yea, does that look like I set it up right? I'm not to sure if I set up my net torque right, but I think I got the other half of the equation correct.

[Doc Al]

Originally posted by Juntao

r-r*m2*g*sin .471=[I(rod)+I(point mass)]*alpha


Looks good except for the left hand side of the above, which is the torque. I think you're mixing up the angles.

[Juntao]

Ok. I re-tried it with 207 degrees, or 3.61 radians, but that new angle still doesn't give me the right answer. I get an alpha of 5.85 /sec^2.

[Doc Al]

Originally posted by Juntao
Ok. I re-tried it with 207 degrees, or 3.61 radians, but that new angle still doesn't give me the right answer. I get an alpha of 5.85 /sec^2.
Not sure what you are doing. The torque is r*F*sinα, where α is the angle between the r and F vectors. But in this case: torque = r*mg*sinα = r*mg*cosθ, by the definition of θ in your diagram. Make sense?

[Juntao]

Yea, now it does. Should have said that earlier, but I'm greatfully grateful for your help. I've spent at least an hour on this, but now I'm done. :)