Digital controller: how to programm it?

[Oxygenne]

Hi!

I have to use a Honeywell-Mellen controller UDC 3200.
To heat up to 1000°C with 5°/C min.
I was programming as follwing:
SRAMP
Time:250
EU/HR: 8500
GAIN: 60.0

but is is still fast heating ?
Have you any idea how to do it?

Thank you in advance!

[NoTime]

Read the datasheet?

Your question doesn't look like programming problem.
It looks more like you are asking about heating element constraints.

[Oxygenne]

I am asking how to set the programm because I have the problem that is too fast heating.
I do not know what is wrong.

[berkeman]

1000C, eh? Hot dog! On our ovens, the ramp rate is set with the RATE variable. Does your machine have something similar?