Register to reply

Is permissible stress and tensile strength the same?

by socrates_1
Tags: permissible, strength, stress, tensile
Share this thread:
socrates_1
#1
Dec7-12, 03:06 PM
P: 27
Hi, I am trying to find out if permissible stress and tensile are the same.If not,what is their relation?Thank you.
Phys.Org News Partner Engineering news on Phys.org
ESA investigates an alternative, environmental-friendly method of corrosion resistance
The oscillator that could makeover the mechanical watch
Engineers study bats to improve aviation travel
Studiot
#2
Dec7-12, 03:28 PM
P: 5,462
First thing to decide is if you mean tensile strength as in your title or tensile stress as your post implies.

Tensile stress refers to a type of stress.
Strength refers to the maximum possible stress of that type that can be applied without failure.
So tensile strength refers to the maximum possible tensile stress, at which point the subject fails.

Permissible stress refers to an amount of stress that will not cause failure.

You should look up 'factor of safety.'

This is the ratio of the strength to permissible ie maximum to permissible and is usually in the range 2.5 : 1 to 8 :1.
socrates_1
#3
Dec7-12, 03:34 PM
P: 27
Quote Quote by Studiot View Post
First thing to decide is if you mean tensile strength as in your title or tensile stress as your post implies.

Tensile stress refers to a type of stress.
Strength refers to the maximum possible stress of that type that can be applied without failure.
So tensile strength refers to the maximum possible tensile stress, at which point the subject fails.

Permissible stress refers to an amount of stress that will not cause failure.

You should look up 'factor of safety.'

This is the ratio of the strength to permissible ie maximum to permissible and is usually in the range 2.5 : 1 to 8 :1.
Thank you very much for your response 'Studiot'.
I refer to tensile strength.I know this relation with the factor of safety,but I just have the Lewis factor and premissible stress of the gear,and the calculator for maximum load through Lewis equation requires the tensile strength.I dont have the factor of safety.
Is there any other way to find tensile strength?

Thanks again.

Studiot
#4
Dec7-12, 06:30 PM
P: 5,462
Is permissible stress and tensile strength the same?

section 7.5 here for instance provides various safety factors.

http://nptel.iitm.ac.in/courses/IIT-...II/pdf/2_7.pdf

You should note that such factors in modern design are compound factors and are called load factors.
Modern design also provides factors applicable to the strength of a material. The strength used is known as the 'characteristic strength' and is measured according to some standard scheme.

Edit

Please note further that you either apply the safety factor to the stress to achieve a safety factor and use the actual nominal loads.
This is the older simpler method called the permissible stress approach.

or

You apply the safety factors to the loads and material properties but use the actual stresses calculated.
This is the more modern, more complicated method, known as limit state analysis.

You do not apply both.


Register to reply

Related Discussions
Finding flexural compressive stress and tensile stress Engineering, Comp Sci, & Technology Homework 2
Tensile Strength and Tensile Strain Mechanical Engineering 9
Truss stress... compressive/tensile stress Mechanical Engineering 1
What is tensile strength? Introductory Physics Homework 18
Tensile strength General Physics 3