Register to reply

Problems with Nuclear Fusion

by Ansuman
Tags: fission, fusion, nuclear power
Share this thread:
Ansuman
#1
Feb24-13, 07:27 AM
P: 16
Nuclear power plant which use of fission process have been made but why not fusion power plants, what affect its feasibility ??
Phys.Org News Partner Science news on Phys.org
Pilot sites in energy from coffee waste show good results
Startups offer banking for smartphone users
Factor in naked mole rat's cells enhances protein integrity
Simon Bridge
#2
Feb24-13, 07:58 AM
Homework
Sci Advisor
HW Helper
Thanks
Simon Bridge's Avatar
P: 12,911
This is an active area of research.
So far, nobody has been able to produce a controlled fusion reaction that outputs the same (or more) energy than it uses. A quick google will show you lots of things that have been and are being tried.
Drmarshall
#3
Feb24-13, 08:00 AM
P: 31
Quote Quote by Simon Bridge View Post
This is an active area of research.
So far, nobody has been able to produce a controlled fusion reaction that outputs the same (or more) energy than it uses. A quick google will show you lots of things that have been and are being tried.
It is thought to require millions of degrees for several seconds.

Astronuc
#4
Feb24-13, 08:08 AM
Admin
Astronuc's Avatar
P: 21,875
Problems with Nuclear Fusion

Quote Quote by Ansuman View Post
Nuclear power plant which use of fission process have been made but why not fusion power plants, what affect its feasibility ??
The fusion process has yet to be perfected.

There are various efforts ongoing, particular the international program, ITER, near Cadarache.
www.iter.org - ITER is under construction in southern France adjacent to the CEA Cadarache Research Centre, located in the commune of Saint-Paul-lez-Durance.

http://www.ccfe.ac.uk/ - Abingdon, Oxfordshire, UK

http://www.pppl.gov/ - Princeton, NJ, US

https://fusion.gat.com/global/Home - General Atomic, CA, US

and others

Most experimental systems have been exploring ways to heat and stabilize the plasma. Along the way, they have also discovered the challenges of confining plasmas long enough to sustain a fusion reaction.

Other attempts have been made with inertial confinement, which currently looks pretty dismal. https://lasers.llnl.gov/
Simon Bridge
#5
Feb24-13, 08:45 AM
Homework
Sci Advisor
HW Helper
Thanks
Simon Bridge's Avatar
P: 12,911
It is thought to require millions of degrees for several seconds.
Muon catalyzed fusion does not require such high temperatures - it's use for power generation keeps coming up but afaik nobody has made much headway. The trouble there is that muons don't last and they cost a lot to make.
Ansuman
#6
Feb24-13, 08:45 AM
P: 16
Quote Quote by Astronuc View Post
The fusion process has yet to be perfected.

There are various efforts ongoing, particular the international program, ITER, near Cadarache.
www.iter.org - ITER is under construction in southern France adjacent to the CEA Cadarache Research Centre, located in the commune of Saint-Paul-lez-Durance.

http://www.ccfe.ac.uk/ - Abingdon, Oxfordshire, UK

http://www.pppl.gov/ - Princeton, NJ, US

https://fusion.gat.com/global/Home - General Atomic, CA, US

and others

Most experimental systems have been exploring ways to heat and stabilize the plasma. Along the way, they have also discovered the challenges of confining plasmas long enough to sustain a fusion reaction.

Other attempts have been made with inertial confinement, which currently looks pretty dismal. https://lasers.llnl.gov/
but these r only 4 experimental purpose and can't be used for energy production ( googled some stuff ).....anyway thanks for the help.
Astronuc
#7
Feb24-13, 08:50 AM
Admin
Astronuc's Avatar
P: 21,875
Quote Quote by Ansuman View Post
but these r only 4 experimental purpose and can't be used for energy production ( googled some stuff ).....anyway thanks for the help.
Yes - they are ongoing research programs. The objective has been, and still is, to develop fusion to the point where it is commercially viable. That objective has proved elusive over the last 6 decades. If it was so simple, we'd have commercial fusion plants.

Sustained confinement of fusion plasmas has not yet been achieved such that fusion is ready for commercial application. The research has however been moving in that direction, albeit rather slowly. The objective of ITER is to approach the minimum conditions for sustainable fusion, however, it could very well fall short of commercial viability.
Ansuman
#8
Feb24-13, 08:50 AM
P: 16
Quote Quote by Simon Bridge View Post
This is an active area of research.
So far, nobody has been able to produce a controlled fusion reaction that outputs the same (or more) energy than it uses. A quick google will show you lots of things that have been and are being tried.
i understood that it requires about 10 million K to initiate a fusion reaction but since the energy output is not high as the input it would not initiate further reactions......so what is meant uncontrollable reaction

To explain my doubt-
Suppose energy input for fusion= x
and energy output = y
and as I have found on google x>y, as technology developed till now allows
hence the output from one reaction would not b sufficient to initiate another reaction since required energy will be x but energy available will be y only

so there is no need of controlling it unlike fission reactors where moderators are used to slow down neutrons...isn't it
Ansuman
#9
Feb24-13, 08:53 AM
P: 16
Quote Quote by Astronuc View Post
Yes - they are ongoing research programs. The objective has been, and still is, to develop fusion to the point where it is commercially viable. That objective has proved elusive over the last 6 decades. If it was so simple, we'd have commercial fusion plants.

Sustained confinement of fusion plasmas has not yet been achieved such that fusion is ready for commercial application. The research has however been moving in that direction, albeit rather slowly. The objective of ITER is to approach the minimum conditions for sustainable fusion, however, it could very well fall short of commercial viability.
so after these all experiments have been done, is there any chance to use the same technology to make commercially viable plants in near future
Astronuc
#10
Feb24-13, 09:05 AM
Admin
Astronuc's Avatar
P: 21,875
Quote Quote by Ansuman View Post
so after these all experiments have been done, is there any chance to use the same technology to make commercially viable plants in near future
If ITER is successful, then perhaps there is a chance - depending on how successful the experiment is.
Simon Bridge
#11
Feb24-13, 09:49 AM
Homework
Sci Advisor
HW Helper
Thanks
Simon Bridge's Avatar
P: 12,911
Quote Quote by Ansuman View Post
but these r only 4 experimental purpose and can't be used for energy production ( googled some stuff ).....anyway thanks for the help.
The question asked was "why not fusion plants" and these examples show you why not.
Quote Quote by Ansuman View Post
i understood that it requires about 10 million K to initiate a fusion reaction but since the energy output is not high as the input it would not initiate further reactions......so what is meant uncontrollable reaction
I'm making a (somewhat glib) reference to thermonuclear weapons. This approach to getting a fusion reaction works but is not feasible for power generation for, hopefully, obvious reasons.

Anyway - you don't have to have a chain reaction for the a thing to be uncontrollable.
Women and cats spring to mind...
mheslep
#12
Feb24-13, 12:51 PM
PF Gold
P: 3,098
Quote Quote by Simon Bridge View Post
Muon catalyzed fusion does not require such high temperatures - it's use for power generation keeps coming up but afaik nobody has made much headway. The trouble there is that muons don't last and they cost a lot to make.
... muons cost a lot of energy to make, relative to the energy resulting from the fusion process.
Joseph Chikva
#13
Feb24-13, 01:15 PM
P: 202
Quote Quote by Astronuc View Post
Along the way, they have also discovered the challenges of confining plasmas long enough to sustain a fusion reaction.
Joint European Torus
http://en.wikipedia.org/wiki/Joint_European_Torus
"Lifetime of the plasma: 5–30 s"
This is more than enough. For ITER this parameter should be even longer.
The problem more in the achievable temperature. As density is also enough but reactivity of plasma is still low due to low temperature achieved.

ITER has projected Plasma Internal Energy about 520 MJ and total Heating Power about 70 MW. Neglecting energy losses they need 520 / 70 = 7.4 sec for increasing internal energy till required value.
More power will turn TOKAMAK out from stability area. That is a real problem.

Also neutral beam injection NBI is technically inconvenient for practical reactors way as assumes the direct connection of gas filled "neutralizer" with vacuum camera (reactor vessel).
http://www-users.york.ac.uk/~bd512//...lecture_08.pdf See Figure on page 19
Astronuc
#14
Feb24-13, 02:11 PM
Admin
Astronuc's Avatar
P: 21,875
Quote Quote by Joseph Chikva View Post
Joint European Torus
http://en.wikipedia.org/wiki/Joint_European_Torus
"Lifetime of the plasma: 5–30 s"
This is more than enough. For ITER this parameter should be even longer.
The problem more in the achievable temperature. As density is also enough but reactivity of plasma is still low due to low temperature achieved.

ITER has projected Plasma Internal Energy about 520 MJ and total Heating Power about 70 MW. Neglecting energy losses they need 520 / 70 = 7.4 sec for increasing internal energy till required value.
More power will turn TOKAMAK out from stability area. That is a real problem.

Also neutral beam injection NBI is technically inconvenient for practical reactors way as assumes the direct connection of gas filled "neutralizer" with vacuum camera (reactor vessel).
http://www-users.york.ac.uk/~bd512//...lecture_08.pdf See Figure on page 19
30 s does not a commercially viable reactor make. Try 30 days, then 30 months, and even 30 years with a capacity of greater than 0.90, and preferably greater than 0.95.
Joseph Chikva
#15
Feb24-13, 10:43 PM
P: 202
Quote Quote by Astronuc View Post
30 s does not a commercially viable reactor make. Try 30 days, then 30 months, and even 30 years with a capacity of greater than 0.90, and preferably greater than 0.95.
TOKAMAKs always (from the beginning till now) was thought as pulse machines. Recall that current required there for creation of poloidal field is an induced current and therefore is a pulse current.
But now modern TOKAMAKs start driving current by conventional for them induction mode and then current is driven by neutral particles beam (the so called "beam driven current").
This allows prolongation of pulse (desired goal in 70s of last century was about 1 s, Lawson criterion (double product) was counted as IIRC 1.5E20 sec/m3 and this parameter has been achieved) and also allows running in so called “H-mode” (high confinement mode discovered in IIRC 1986 in German TOKAMAK.
ITER is indented for longer pulse then 30 sec - approximately 1000 sec. But in either way machine is indented to run "pulse by pulse" or "shot by shot".
As result pulse neutrons flux bombard lithium blanket with releasing more energy from "n+Li6" reaction from where coolant takes that energy for running e.g. then steam turbines in nonstop mode.
Simon Bridge
#16
Feb25-13, 12:19 AM
Homework
Sci Advisor
HW Helper
Thanks
Simon Bridge's Avatar
P: 12,911
Quote Quote by mheslep View Post
Quote Quote by Simon Bridge
Muon catalyzed fusion does not require such high temperatures - it's use for power generation keeps coming up but afaik nobody has made much headway. The trouble there is that muons don't last and they cost a lot to make.
... muons cost a lot of energy to make, relative to the energy resulting from the fusion process.
Just in case someone thought I meant the dollar cost? Fair enough.

I didn't want to write too much in case nobody was interested. Considering the rest of the thread - it seems nobody is :) I suppose readers should also be aware that the experimental break-even point is just where energy in matches energy out ... a power reactor needs to do better if it is to provide it's own operating power, and a commercially viable reactor even better since it has to make a profit.

I was more interested in pointing to an example of low-temp fusion that wasn't junk science.

Fusion does not have to involve very high temperatures but:
1. the high temperature projects look like they have more promise these days
2. there is a lot of junk and pseudo-science around low-temp fusion ideas to trap the unwary investor.
d3mm
#17
Feb25-13, 08:36 PM
P: 139
Quote Quote by Simon Bridge View Post
I'm making a (somewhat glib) reference to thermonuclear weapons. This approach to getting a fusion reaction works but is not feasible for power generation for, hopefully, obvious reasons.
Not all fusion research is for power. More than a few fusion dollars go into weapons research. For example it is the main mission of NIF fusion lab in America. I wonder what percentage of the total fusion budget is split this way.
Joseph Chikva
#18
Feb25-13, 11:22 PM
P: 202
Quote Quote by d3mm View Post
Not all fusion research is for power. More than a few fusion dollars go into weapons research. For example it is the main mission of NIF fusion lab in America. I wonder what percentage of the total fusion budget is split this way.
Power generation is much significant challenge than task of improvement (and not creation) of weapons that never be used and huge inventory of which is already in existence.
Simply, low energy efficiency of today's lasers (not more than 1%) defines impossibility for NIF program to enter in power generation sector. Simply you should pump into the laser 100 J for pulse energy 1 J that goes to the thermonuclear target (hohlraum) which at Q=5 gives you fusion energy 5 J which then should be converted into the electricity with 50-60% of efficiency. So, in the best case spending 100 J you gain 2.5-3 J.
We need go two ways for laser inertial fusion:
1. To improve efficiency of laser at least on order of magnitude
2. To improve Q factor of hohlraum on 1, 2 and better 3 orders of magnitude.
Both these ways have some difficulties and at today's level of technology have very limited opportunities of further improvement.
But people involved in NIF say that they can simulate the weapon. And they've got financing from the DOD in excess of DOE. I think that only this is the reason why NIF is considered as weapon program.


Register to reply

Related Discussions
Nuclear fusion (requirements to start fusion) High Energy, Nuclear, Particle Physics 9
Nuclear Fusion and Nuclear Fission, safety and efficiency Nuclear Engineering 9
Working on nuclear fusion as nuclear physicist Academic Guidance 13
Nuclear fusion and the end of energy problems claim Nuclear Engineering 18
Nuclear fusion General Physics 9