Recent content by ahmad.hasan

  1. A

    Study Finite Element Methods: Books & Resources

    i start studying Finite element Methods any one who can help me on this subject, any good refrence book on this topic or other helping book.
  2. A

    Difference between accuracy and resolution

    Accuracy: accuracy is the maximum spread in measurements made of slide movements during successive runs at a number of target points Resolution: Resolution refers to the smallest units of measurement that the system can recognize.
  3. A

    Throttling Process & Joule Thomson Effect

    what is the value of joule-thomson coefficient for methane
  4. A

    Material Selection: Al-Mg-Si-Fe Alloy

    Please help me in selecting material Selection the % is given Al=82.918%,Mg=0.063%,si=12.603%,Fe=0.991,cu=2.612%,Mn=0.188%,cr=.038%,Ni=0.131%,Zn=0.118%,Sn=0.188%,Ti=.069%,Pb=0.181% what will be the name of material.
  5. A

    Throttling Process & Joule Thomson Effect

    no it is going throug valve (sloninoid valve) from storage cylinder through high pressure pipe into solinoid valve and then in the 1st stage chamber of pressure regulator.
  6. A

    Design CNG Kit | Get Expert Tips & Advice

    pressure drops in pressure regulator from 300 bar to 4 bar in 1st stage chamber due to expansion how you can corelate pressure volume and temperature as temperature also drops in it
  7. A

    Throttling Process & Joule Thomson Effect

    Pressure drops in CNG kit Pressure regulator from 300 bar to 4 bar in 1st chamber due to expansion is it throttling process? temperature also drops in it.
  8. A

    Throttling Process & Joule Thomson Effect

    dear all What is the throttling Process? what is Joule homson Effect?
  9. A

    Design CNG Kit | Get Expert Tips & Advice

    Thanks for guiding me FredGarvin pressure reduces in the pressure regulator of CNG kit when Gas enters the Chamber of it due to Expansion how we can co relate pressure and volume? to reduce pressure from 300 bar to 4 bar and we know the initial volume how we can get the chamber volume.
  10. A

    Other Becoming an Engineer: Considerations and Personal Experiences

    question: Should I become an engineer? yes i am sure Question: What engineering discipline should I study? Mechatronics
  11. A

    Design CNG Kit | Get Expert Tips & Advice

    basically CNG (compressed Natural Gas) it is now a days used in vehicles instead of Gasoline fuel. CNG kit is a complete system. compressed gas is at 300 bar in storag cylinder. it is brought upto the pressure of 2 bar after passing throug pressure regulator in CNG kit then this gas enters the...
  12. A

    Design CNG Kit | Get Expert Tips & Advice

    Dear all! hi i am working on project "design of cng Kit" ,Please help me in this regard.