Recent content by ahmedi811
-
A
Drafting question - weld symbol question
Thank You Sultan. I appreciate your willingness to help as I am trying to model that joint on ANSYS to run FEA and obtain Hot Spot Stresses around the joint periphery. You are right. I think this variable refers to the angle between the brace bevel and the chord. This angle still varies...- ahmedi811
- Post #10
- Forum: Mechanical Engineering
-
A
Drafting question - weld symbol question
Thank You Sultan. However, if you look at the bottom of the diagrammatic representation you will find a table with variable values of 'ψ' describing the very same brace but saying Part A, Part B and C referring to the diagram on the top. That is, as you start from the left towards the right, the...- ahmedi811
- Post #8
- Forum: Mechanical Engineering
-
A
Drafting question - weld symbol question
Can anybody explan what does the angle 'ψ' represent in the diagram...- ahmedi811
- Post #5
- Forum: Mechanical Engineering
-
A
Residual stress simulation on Ansys
How can I model weld residual stress for K-Joint Tubular Joints in ANSYS?- ahmedi811
- Post #11
- Forum: Mechanical Engineering