Recent content by amir azlan

  1. A

    Finding the maximum load of a bar from the yield strength

    I have a flat steel bar (30 mm width, 5 mm thick, 1100 mm long). The bar has a load applied in the centre of 100N. the bar is fixed at both ends with a single concentrated load P applied mid-span the maximum yield stress is 250 MPa (250x10^6 Pa) How do I calculate the maximum load the bar can...
  2. A

    Beam Deflection equation question

    Yes, the dimension of the beam: 30mm width, 5mm thick
  3. A

    Beam Deflection equation question

    For the moment of inertia,I of the beam,is it still calculated using the formula ?
  4. A

    Beam Deflection equation question

    yes,these holes are drilled to hold the beam onto the frame using bolts.
  5. A

    Beam Deflection equation question

    Attached is the the drawing of the beam. 3 holes drilled to each end of the beam. How to calculate the max deflection of beam, as the given formula of δ=(PL^3 )/(48EI) is no longer valid?
  6. A

    Beam Deflection equation question

    regarding this equation, δ=(PL^3 )/(48EI) For the calculation of maximum deflection, if my structure is not longer a full form beam (meaning the structure has 6 holes drilled to it), can this formula still be used?is...