Thanks!
Yea the top link is constrained by the chassis rail..pretty much runs along at the same angle & has maybe 80mm to slot into on upwards travel between the chassis and sump, I should have more scope for mounting on the rear. That's sparked another thought actually, is there any...
Thanks for the input Mike.. I'm getting there with my numbers.. This is my existing(ish) setup..
And this the proposed(ish)..
I'll probably aim for a bit more vertical separation at the axle end (top link up a bit). The main query however was running the PHrods 'crossed up' any...
Hi Guys, slightly off topic this one, as in where the discussion is at present & not strictly being a race car (allbeit an offroad racer)
Im building an off road truck at the moment, I've already put together a 3-link setup on the front which ran airshocks. I'm re-designing it to run coilovers...
[SIZE="2"]Moderator's note: thread moved from Homework Help forums to Mechanical Engineering forum. Welcome to PF an1mal_69 :smile:
Apologies, this is not homework, but a real world problem.
Homework Statement
Front suspension system, consisting of 2 wishbones supporting a wheel hub via...