Recent content by aniruddha

In the analysis of Random vibration, we use the PSD curves as the input, I am confused as to why we simply don't use acceleration versus time graph but instead convert it into g^2/Hz and Hz.

Since the flow of heat in solids happens due to the collision of the molecules with each other, thereby increasing their internal energy, a higher denser material will have molecules closer, does it mean that the thermal conductivity of high density materials will be higher than the lower...

What are the kind of loads that act on an automobile door frame while opening, closing other than the load on the hinge?

but i have seen a few suppliers of acrylic saying that their material doesn't yellow when exposed to sunlight and UV rays and some even give a warranty of 10 years. i agree that the cars side glasses must me shatter-able so as to break open during emergency, but i suppose for other type of...

I just wanted to understand what are the main properties required for an automobile glass. I understand that for a windshield of an automobile, the material must have high impact resistance but do compressive and tensile strengths also matter that much? For the window glasses in automobiles...

Hi, I just wanted to know what is the effect of axial force on drill bit? does it amount to the axial load on the spindle to which it may be mounted?

I have this doubt on spur gears Is it necessary that the pitch circles of the two mating gears need to be tangential? or will a small gap of 0.3mm matter?

Is there any link where i can fully understand these things with some standard equations?? Is there any practical example of a shaft subjected to pure torsion

Hello! Iam a student doing my project at an industry I just encountered designing shafts we use vertical spindles with a gear which meshes with an internal gear near the top end of the spindle, i just wanted to know whether i need to design the spindle for both torsion and bending or should...