Baluncore's latest activity
-
Baluncore replied to the thread Automotive Need to glue aluminum to glass.The problem I see with RTV silicone, is that it will bond well to itself, but poorly to aluminium or glass. Still, if the joint is... -
Baluncore replied to the thread Traction Elevator counterweight overbalanced percentage.I expect that the 40% counterweight is a compromise between reducing the peak ±load on the motor, and increasing the rate of...
-
Baluncore replied to the thread Traction Elevator counterweight overbalanced percentage.What load variation, from minimum to maximum, is being lifted? What load is the geared traction unit specified to lift?
-
Baluncore replied to the thread Automotive Need to glue aluminum to glass.Differential thermal expansion will be a problem if the glue is too good, or the aluminium is too thick. Epoxy or superglue would last...
-
Baluncore replied to the thread Development of a Bike Trainer (rollers).The 620xRS bearings have rubber lip seals that will drag if dry, and may stop the rollers spinning freely. If after cleaning and oiling...
-
Baluncore replied to the thread Traction Elevator counterweight overbalanced percentage.Welcome to PF. At first reading, it might seem to be OK, but there will always be safety concerns during operation. It is very hard to...
-
Baluncore replied to the thread Development of a Bike Trainer (rollers).The bike wheel is not dropping down far between the rollers, multiplying the friction load, so that is not a problem. I suspect the...