Baluncore's latest activity

Turn it against itself. Just ask google AI, then follow your nose. The upgrade of a module in a rack costs less than replacing the...

Here I compare lumped lines with TLINE in LTspice. I adjusted your lumped lines to have Zo = 50 ohms. I halved the end component lumps...

Your via is an inductor, but if you have not trimmed the track where the via is located, it makes a small parallel plate capacitor in...

There was a time when the accumulating weight of National Geographic magazines was predicted to cause earthquakes and subsidence...

You really make it difficult on yourself by using lumped element transition lines instead of the wide bandwidth TLINE model available in...

Welcome to PF. The positive current spike at the instant of contact is the discharge of the electrode and cable capacitance. I see no...

Multipath interference patterns, or standing waves, can have fine detail at quite some distance. The deep nulls are very narrow, so they...

oops, I should have done the math!

It is not possible to drive Y to zero, unless you brake Y itself. No matter how I juggle the ratios, one of the input gears must be...

Look at the graph, or the table. The output, Y, crosses zero when; X=100.0; A=266.7; B=-66.667; C=133.3; D=-133.3; Y=0.000 You can do...

Here is a table that gives the speed of the shafts, all referenced to an input of 100. A and B are the input shaft gears, the average of...

The Bluetooth signal is a radio wave. So it won’t have any features on the scale of three inches. More likely you were hitting a...

Bluetooth operates at about 2.4 GHz, with a wavelength of 125mm, or 5". You can expect multipath reflections which can give some peaks...

The equations governing this gear set seem pretty simple to me. There are four of them: The gear ratio of the left gear set (##GR_L##)...

No. A pulley would turn freely but remain in position, which will equalise the tension on both sides of the pulley. As shown, the...