Recent content by Gagan

Okay, I get you now. So, there is a common housing for both the bearings and it is clamped on by 4 bolts fastened to a vertical flat plate. I hope this gives clarity.

Thank you! The orientation is back-to-back arrangement (that is indicated by the dotted lines in my sketch) (reference image attached) if that is what you meant by orientation. Yes, you are right but I am not aware of which is what since the setup was manufactured way before I started working...

I apologize in advance for any errors in my concepts or assumptions. Feel free to correct me wherever I am wrong. Thanks in advance for the help. There is a vertical shaft which will be operated at around 600 rpm (N) which can be achieved in 2 seconds (or even 4 just an assumption). The shaft...