Guineafowl's latest activity

Isn’t the full-load rms current of 3.12 A a consequence of the effective, or apparent, impedance under these conditions? As far as I can...

Looking at this another way, this link: https://vfds.com/blog/how-do-you-size-a-line-reactor/ suggests the standard for VFD load...

The VFD was expecting to drive an inductive motor. You raised the frequency of the LPF by 470 / 2.2 = 200 times. That explains why the...

8 kHz Configured as per post #35, the caps are in delta and had to be replaced with 2.2 nF, as the 0.47 uF ones were tripping the VFD...

As before, I can’t get triggering when zoomed in (or out). Is it better to zoom in, and keep taking single shots until a decent picture...

I borrowed a HV differential probe, but it’s telling the same story, ie that the filter is somehow making the waveform messier. 1. No...

No, still glitching.

The mill motor in delta.

Initial results with the digital scope are not quite as expected. Using 100x probes and the CH1-CH2 displayed in the blue window...

The smart TV can use the 5 GHz, but doesn’t as it has a direct ethernet cable connection. Router is about 6m from the tv, but with no...

I was having trouble logging in to the router gateway, but am in now. It uses 2.4 and 5 GHz channels. The 2.4 channel width is already...

I can’t see much from the outside. No access panel for the power board so it’ll be a case of spudging horrible plastic clips all the way...

Model UE55NU8000T, with a ‘smart’ remote operating on Bluetooth (except for the power button, which is IR) and a normal one, which is...

The Rigol has arrived, and I’m just getting familiar with it and waiting for the 100x probes. It’s very nice to be able to capture...

If you insist, then. I’ve ordered the Rigol DHO804, which has some good reviews. Having four channels on the Fluke has been helpful, eg...