Recent content by Hraabo

In the end want to know what know what voltage I can expect to measure, if I put some sort of conductor around the tank.

So I am working on a project where I have a tank, which has a volume of electrolyte liquid inside it. This is coupled to a battery which charges it, and gives it energy. I will have a copperband arround it, so i can measure a potential voltage from the electrical field. So what I need to...

Thank you for you reply, both of you. Well to be a bit more on point, I have to make a DT of the university Power lab, which include units such as Wind turbines, solar panels etc. I am very well aware that I won't be able to make DT of everything, but I was thinking of doing of the wind...

I am also new to it all, so I didn't even know there was several terms for it. The link you added, is the term I know of, so thank you sir for clearing possible misunderstandings up.

So I was wondering what experience you guys have in working with Digital twins? I am currently researching for my graduation project, which is about digital twin. When looking for litterature about digital twin, the amount available is somewhat limited. So what I'm basically asking you guys...

So what you are saying is, that you would perform validation test, and compare them with manufacturer data?

Hello So i was curious to know, what kind of tests you guys would run on a setup, for an AC drive and motor, to see if the controlling works properly? kind regards

Hello I hope someone can help me, as i am kinda stuck for the moment. As you can see, the assignment states that I need to find the poles from the closed loop transfer function. I plan on doing so, by using block diagram reduction method. This is as fare as I've come, and can't come...

Bump - No help? :S

Is that so? Maybe Someone Can Move the post then? And Sorry for the trouble

Hello I hope someone can help me, as i am kinda stuck for the moment. As you can see, the assignment states that I need to find the poles from the closed loop transfer function. I plan on doing so, by using block diagram reduction method. This is as fare as I've come, and can't come further...