Recent content by I forgot ohms

The power supply is a 12-15vdc 15amp. We use them to power battery chargers and tire truer. I race 1/12 scale RC cars. The tire lathe is to cut down foam tires to achieve proper roll out.

It is black brown silver gold. I will check the specs on other resistor. My local distributor has access to five resistor manufacturer , and not a one offer. 01 ohm 2watt. Smallest I could find is .1 ohm 2watt. I guess I could parallel a bunch of .1 but don't have the space.

I have a 12v switching transformer; one of the legs on a black brown silver gold 2w resistor is broken off. I have had zero luck finding a standard .01 2w resistor. I did find a current sensing resistor at the values, but should it be used. The resistor in the power supply is ceramic, I think...

50,000 feet of red and 75,000 feet of black it is all in 25,000 feet barrels... There was a double p.o. put in for it.

I Don't know if this is the correct place for this post but here goes. I am looking for a supply house or distributor who buys wire I have a lot of 1015 22 red and black. I work for a company in carmel indiana who builds wire harnesses. Please point me in the correct direction. Thank you Brandon

The Quencharc or snubber is used to protect the relay in the watlow controller. I have a watlow output relay going to the coil on a mercury displacement switch. I have to per manufacture put the snubber on the coil on the merc switch. so that would put the snubber in parrarell with the 1k...

I have an oven and the heater element is ran by a watlow controller. It is going out evey two or three years. The watlow controller runs a relay to turn element on and off. The relay on the watlow needs a load of 100ma min. to keep contacts clean. I have the resistance of the coil for the on off...