Recent content by IamDev

-Dimension of the water tank is 800x500x350mm. -The level of water is about 100 mm below from the upper edge of the water tank & and rotating disk is approx 1-2 cm below the water level. -Diameter of the disk is 150 mm and thickness is 5 mm and made of mild steel (density 7850 kg/mm3)...

Hello, I need to buy a DC motor for my project work. My project involves rotation of a cylindrical disk of 1 kg, inside water (approx. 2 cm below the water level) at different speed ranging between 100 rpm -200 rpm. For this purpose I need to buy a DC motor but I am not sure of what...

Okay, I have a disk of 8 cm radius and 4 cm thickness and I have to rotate the disk at constant speed of 100 rpm. I need to buy a DC motor to rotate the disk but I am unable to short out the specification of DC motor. Can you help me please?

Is it possible to calculate required torque if we consider that water level will be constant during the whole process?

Hello Guys, I have a disk of diameter of 150mm and thickness of 10mm which is rotating at the constant speed of 100rpm. The disk is inside water which is approximately 4-5 cm below the surface. Disk is horizontal (parallel to the water surface). Disk is attached with the shaft of the motor. At...

Thanks for the reply. 1. Size of workpiece is about 3-4cm in diameter and thickness is about 1 cm (mild steel) and weight will be in between 160-200gm. 2. Rotation should be about vertical axis. 3. Rotation rate range is 100rpm to 150 rpm 4. Rotation should be powered bu DC Motor. 5. Servo EDM...

I need to design a basic setup to rotate the workpiece in Die Sinking EDM Process. I made some design but they were complicated and were not easy to fabricate so I need someone who can help me.