Recent content by Leshok

For Metal I am thinking GWAR and Municipal Waste

How about punk/hardcore leaning towards anti-capitalist or anarchist ideas? Anyone else familiar with the genre?

I always find myself focusing on lyrics to many songs. So I tend to listen to instrumental music such as Explosions in the Sky. I have made a habit of getting a study room and practicing my Math on a chalkboard while listening to them.

I have always used the Pilot Precise V5 Extra Fine Rolling Ball pens. I have always taken notes and solved problems in multipliable colors. Although it is not the colors I like about the pens, it is the feel the Extra Fine point has on paper. HTH

I have the same interest as you and did a little bit of research. There are a few schools that offer a Bachelors in Automotive Engineering Technology. These do not seem to be very marketable and are a lot more vocational than technical. There are two schools that I found that offer a Bachelors...

For the most part, "C's get degrees"

You are correct in preparation of the piston before it is ran. I understand the concepts of compression ratio. I develop performance cylinder heads and engines locally. The preparation of piston face/shape and chamber shaping in very important but irreverent to the original question. Maybe we...

Understood. I did not disagree with what you said about ring land/groove prep. I was only in disagreement if you were instructing that polishing of the top of the piston was in some way beneficial. The perfect engine will have a piston that never makes contact with the cylinder wall. The only...

The material is not the only reason why gas ports are used. The gas ports are also used to seal a very low tension ring at high piston speeds. Is this suggesting polishing the piston crown or piston face? If piston face, I would have to disagree here. Forcing carbon to tightly bond with the...