Recent content by MIKESMIND

  1. M

    Looking for software to help me make electromagnets

    This needs to be proto typed and the math will come from the tests on the unit.
  2. M

    Looking for software to help me make electromagnets

    That is in no way like what I am making. One year would be ok but I think I will need more time. I also may not be selling them. Right now there are 10 to 15 companies that do anything that would like it. This will do it at 1% of the cost.
  3. M

    Looking for software to help me make electromagnets

    I made one like it 30 years ago and this is safe as can be. Testing will be done in a safe area. Working unit will be destructive testing done first. So unless dirt will burn after the power is off I will be safe. I also have water to the under ground room. I was a old bomb shelter.
  4. M

    Looking for software to help me make electromagnets

    It will be in a safe area and tested up to 2000lps slowly
  5. M

    Looking for software to help me make electromagnets

    There is only one moving part and it is the switch
  6. M

    Looking for software to help me make electromagnets

    If it works and I patent it I may tell you
  7. M

    Looking for software to help me make electromagnets

    They are not for lifting I can get them a lot of places
  8. M

    Looking for software to help me make electromagnets

    This is home project that I have wanted to do for years. I know I will have to build a lot of them to get what I need. I am hoping to find some software that will help me. I have looked and I can not find any electromagnets that will work. I will have to have odd shaped cores and they will need...
  9. M

    Copper fins coil with out pipe

    I dont have a kiln yet and I will have to learn how to make the molds as well
  10. M

    Copper fins coil with out pipe

    Not a bad idea but I need it thicker then paper. I may have to go with a mold and get a kiln to melt the copper and let it flow into the mold
  11. M

    Copper fins coil with out pipe

    These are made by many places in china. I would have to buy a few tons of them and drill out the core pipe. Someone in north america must make them. ps I am looking for round slinky shaped not a folded foil like in a car think of it like this drill a 1" hole down the center of a 4" wide by...
  12. M

    Copper fins coil with out pipe

    I am looking for copper fins the same as would be on a heating pipe. the fins need to be like a coil or slinky. If you have ever used or know who makes them please let me know. I am working on an invention and this is one of the parts i need. 2 to 3" OD and 3/4 to 1" ID
  13. M

    High heat high inpact insulator infomation wanted

    The max voltage would be no higher then 80 volts. The curent could go as high as a 2000 amp pulse of about 100th of a second and about 20 a second. These are not fixed the lower the voltage and the higher the curent the better. This unit is going to be like a car hitting a brick wall 20...
  14. M

    High heat high inpact insulator infomation wanted

    Sorry for the delay Yes but what I would like is a metal tube coated with rust on the outside and a good conductor on the inside. Copper is too soft and flattened out in a few minutes. The insulation breaks as well y
  15. M

    High heat high inpact insulator infomation wanted

    I would like to find an insulator that can work in high heat and take a beating. A strong metal would be nice. It will be taking a beating and it will have to hold the copper in it form or the copper will flattened out
Top