The steam is supplied from a boiler room at a constant pressure of 5 bar via 2 inch pipes. It enter a mold cavity via 2 inch insulated piping. The mold cavity where the plastic material is molded is 15 cm x 6cm x 5cm. The steam enters this cavity through small ports on the surface of the mold...
Thank you very much for your reply.
I am working with plastic foam processing. We use a machine called steam-chest molder. Very common products molded with this machine are the EPS products. Basically the machine uses steam to melt plastic particles and sinter them together to form three...
If i am supplying steam at a pressure of 3.8 bar (temperature at this pressure is 142 C) and the steam flow gets blocked. Does the temperature of the steam increase at the same pressure?