Recent content by Priesthood
-
P
Mini PowerPoint Remote: Build on 3/4" x 1" Board?
I'd like to attempt to build a mini wireless PowerPoint remote that simply moves back and forth through slides...that's it...two buttons. I'm trying to see if I can fit the entire design on a board no larger than 3/4" x 1"...is this possible? Also, the receiver would need to be a wireless USB...- Priesthood
- Thread
- Replies: 1
- Forum: Electrical Engineering
-
P
RC-Blimp propulsion system on larger a larger scale
When I say static, I mean that the ducted fans ON the jet pack are in a fixed position unlike the blimps ducted fans that rotate. Yes, the jet pack does have the ability to move around in the same manner I am looking for, but I am also not trying to copy their design. That's why I posted on...- Priesthood
- Post #5
- Forum: Mechanical Engineering
-
P
RC-Blimp propulsion system on larger a larger scale
I am aware that a blimp uses those ducted fans simply for directing is travel through the air. I am trying to see if it is possible to create a system that can both lift and direct. The Martin Jet Pack as seen in the link below uses ducted fans for lift, but the system is static. My ultimate...- Priesthood
- Post #3
- Forum: Mechanical Engineering
-
P
RC-Blimp propulsion system on larger a larger scale
Hi everyone, and thanks for reading my very first post in Physics Forums! I have been researching a way to construct a single person aircraft with vertical take-off and landing using a propulsion system similar to that of an RC-blimp. I found a video on youtube that illustrates the principle...- Priesthood
- Thread
- Propulsion Scale System
- Replies: 4
- Forum: Mechanical Engineering