Recent content by Satvir

Ideally looking for a max of 2 per pair of roller

Would Steel be a better choice and if aluminum were use then how long would you say it would last taking into mind it will be spinning around to keep the paint mixing at very low speed. The paint can dimension: Height: 25cmn Diameter: 18.4cm Could you please post the formula so in the future I...

Hi all, I'm going to make a roller shaft for a roller mixer. I will be using a aluminum tube of length 900mm placed horizontally and the two ends will be help in a bearing. An another pipe will be placed side by side to the first pipe with a bit of space in the middle and held the same way as...