Recent content by Scott Q

I intended the seal itself to adhere the oscillating opening to a static interface.

The fluid is air and the pressure unknown at this point; however, It should not be very large, probably ~2 kPa. It will depend on the resistance of the check valve I'm going to use. I haven't been able to locate a suitable valve so I'm designing my own and it's performance is unknown atm. What...

Hello Everyone, I'm looking for a sealing membrane, or comparable solution, to seal a thin opening (~15mm x 2mm) that oscillates elliptically, like in my example picture below, with a low amplitude (+/- 1mm) and frequency in the 100s - 1000s of Hz range. Any ideas?