Recent content by vishal badal

  1. V

    Calculating Liquid Density in a Closed Circuit

    dont u have a sample port opening in the circuit?
  2. V

    Solving Gear Pump Cavi Mystery - No Priming Needed

    strange things happen! may be the clearance between gear and casing or between two gears, had increased causing back leakage...which might have not able to produce the initial vacuum for the suction...so might had need priming...and after priming...it could had discharged the liquid but with...
  3. V

    Pressure Difference: Problem Solving Guide

    please..go thru the attachment drawing and problem statement...
  4. V

    Water Tank Design: Pressure Calculation

    depend on weather the pressure vessel has the fluid inside in it has static or dynamic in nature... cause if the sand is continuesly coming in and going out of the vessel; then in that case the design will b different and very critical...in that case stress concentration will come in picture...
  5. V

    What Are the Largest Gear Ratios Possible for a Steam Turbine System?

    it will depend on the torque required at higher level...cause module is dependent on that...also the shaft diameter will also come into picture...with its cost...i m not getting weather ur asking for a model or for a protocol?
  6. V

    Fluid Dynamics interesting critical problem

    great answer... i was exactly worried about this...but after getting empty...will the 2nd tank will never get filled ?
  7. V

    Fluid Dynamics interesting critical problem

    your explanation sounds convincing... but the suction of the pump is too high and the 2nd tank is diameter is very small... so will this make any difference... weather it will be dependent on the suction of the pump??
  8. V

    Fluid Dynamics interesting critical problem

    r u sure about this?? because what i feel; there is only 1 directional flow is possible in a pipe... so in the 2nd bypasss pipeline...if liquid strat coming out towards the pump...can simultaneously the liquid from 1st tank will go to the 2nd tank... refer figure attached...2 tank...
  9. V

    Fluid flow problem- pressure vs momentum

    thanx... my concern is to keep the level of 2nd tank same as that of that of 1st... it could have been possible easily if had connected the pipe from 2nd tank to 1st tank directly...rather line its discharge line... now because i am connecting it to the bottom pipe of 1st; will it make...
  10. V

    Fluid Dynamics interesting critical problem

    Thanks 4 ur response... But i think, when the pump will start sucking fluid from both the tanks; how can the flow from 1st tank to 2nd tank is simultaneously possible when the fluuid from 2nd tank is also being sucked by pump... u have got my concern; what i care about is the level of...
  11. V

    Fluid Dynamics interesting critical problem

    Thanks bro... i m a new user... Please go thru my problem .. i have attached a drawing for reference...
  12. V

    Fluid Dynamics interesting critical problem

    I am having a tank at the bottom of which a pump suction line is connected.. there is another parralel line to that bottom line which is coming from another tank and open to atmospheric pressure. Please note that this second pipe is connected to the bottom pipe; not to the first tank...
  13. V

    Fluid flow problem- pressure vs momentum

    Please find the attachment of a drawing for ready reference...named tank problem... thanks for the reply... please do the needful..
  14. V

    Fluid flow problem- pressure vs momentum

    Please find the attachment in the form of a drawing for ready reference..
  15. V

    Fluid flow problem- pressure vs momentum

    I am having a tank at the bottom of which a pump suction line is connected.. there is another parralel line to that bottom line which is open to atmosphere. Please note that this second pipe is connected to the bottom pipe; not to the tank... there is only flow inlet to the tank...